咨询热线：
| 检测项目Test item | 标准要求 Standard request | 实测值 Measured value |
| 硬度（绍尔A ) Hardness(Glenn Schorr/A) | ≥75A | 90A |
| 抗撕裂强度Tearing strength | ≥ 20 KN/m | &28 KN/m |
| 拉伸强度 Tensile strength | ≥ 8.2 KN/m | 10.20 KN/m |
| 磨耗性能 Abrasion performance | ≤ 250 mm3 | 220 mm3 |
| 受热尺寸变率 Heat size variability | 名 ±0.4G/o | -0.12% |
| 压缩永久变形Compression set | ≤ 0.2mm | 0.09mm |
| 耐烟头灼烧 Resistance of cigarette clcination | 无烧痕 | 无烧痕 |
| 阻燃性 H「e resistance | ≥B1 | B1 |
| 耐化学品污染 Resistance to chemical pollution | 表面无变化 | 表面无变化 |
| 耐光照性 The light resistance | ≥灰卡标3级 | 3级 |
| 抗弯曲性能 Resistance to bending performance | Φ020mm金属棒弯曲180°无裂纹 | 无裂纹 |
1.地面状况：坚硬，平整，干燥，洁净的水泥地面，钢板，铝板，木板地面或水泥自流坪，环氧自流坪地面，地面相对湿度小于5%,现场湿 度大于15度。
2.胶粘剂，使用专业配套的单组份胶，双组份胶或万能胶，并遵照地板供应商的意见采购。
3.施工工具：配套专业的裁切刀，刮胶板，压轴，橡胶锤等工具。
4.施工人员：必须要有经验的专业人员施工，切忌使用一般人员。
1.Ground conditions: hard, flat, dry, clean of the cement ground, steel plate, aluminum plate, wood or cement their flat on the ground, epoxy artesian ping on the ground, the ground is less than 5% relative humidity, the humidity is more than 15 degrees.
2.Adhesive, using professional supporting one-component adhesive, a two-component glue or adhesive, and follow the opinions of the floor supplier sourcing.
3.Construction tools: supporting the professional cutting knife, plastic board, finale, rubber hammer tools.
4.Construction personnel: must have experience in professional construction, avoid to use the general staff.
1.产品具有良好的耐磨性、耐污性、环保性。
2.防火阻燃性、静音性。
3.产品具有耐冲击、防滑、减震的作用。
4.产品具有不变形、不开裂翘边且膨胀指数低。
5.产品适用于各地的机场、地铁、医院、商场、学校及工业等场所。
1.Products with good abrasion resistance, dirt resistance, environmental protection.
2.Fire flame retardancy, mute.
3.Product has impact resistance, slip resistance, shock absorption effect.
4.Products have not deformation, not cracking become warped edge and low inflation index.
5.Around the product is suitable for use in airport, metro, hospital, shopping malls, schools, and industry etc.